Trigger problem

It is something to do with your magnetic sensors. the easiest thing to do would be stop pulling the trigger at an angle, but seeing as thats not a permanent fix you will need to realign your board sensors. inside the grip frame is the board and within the two black "guards" protecting the board are three sensors. the single one (closest to the solenoid) is your safety/selector sensor, that one seems fine seeing you can shoot different modes. the two in front (face of the board) is the trigger sensors, every time the trigger magnet passes between these two the marker fires. what i am guessing is one or both of these are out of whack. ideally they should be equal distance apart from each other pushed up against their "guards". just be careful when adjusting these as they can be snapped off or damaged. if that fails contact tippmanns service center directly.