32 degrees coil

I recently purchased a 32 degrees coil and was wondering if anyone else has one that could tell me how to use it.... yea, iv never used a remote coil before so idk much about them and the included directions are vague.  I know I have to skrew one end on the co2 can, but what is the knob for? then there is a quick detach part which i attach to the coil then skrew into the gun.  What is a slide check and does it already have one on? (if n0t are there any specs as to what I should look for and how much they cost?) also, while i think i know what an ASA is, what does the acronym stand for?  Also, with the coil, what is the procedure for attaching/detaching regarding safety and pressure and such.....wow, i feel just a lil bit spetha axin all this.....

OK hers the best I can do

Frist there should be a round threde piece witch the quick conect snaps
on to you screw that into the gun.

Second make sure the nob on top of the tank part is out far enough that
the pin in the midel is flush with the top of the inside part (I put my
finget in the tank end of the coil were the threds are and back out the nob
on top till the pin is flush with the top) then screw the tank end on the
tank( dont panic the pin is not down it will not let air out.)

Third snap the quick conect on to the adapter to the gun.

Forth Screw the nob down on the top of the tank this will push the pin
down and alow air in the gun.

To remove

I turn the air off by unscrewing the nob on the top of the tank. make sure
the gun has no pain in it and fire it till the gun is out of air.

Then un do the quick conect and unscrew the tank from the coil.

Ther I hope you understand all this

Edited by Giblin

Konig42 wrote: thank you that helped quite a bit actually.. the only questions that remain are about the slide check and what happens if the line is still  pressurised while disconneected. tnx

Slid check i think (dont qoute me on this im not sure mine dose not have
this) is a way to release the air presue out of the coil with out firing the
gun.

If you disconect the coil wile pressuriesed you will drain your tank. Dont
worry I cant get the quick conect of my gun with out depressurising my
gun there is to much prusser in the coil to alow you to do this.

Edited by Giblin