low pressure system

I wanted to know if i should get a low pressure system or/and a palmer stabilizer & what would be the improvements ( my complaints r :not accurate,1shoot here,next shoot way out there).My setup is:

A-5,r/t or e-grip w/ WAS board,JCS Red Hot Power Tube,hpa 4500 88ci, apex, j&j & bigshoot.

Edited by KALIS-PIMENTA - 20 February 2006 at 2:31pm

Tippmann A-5
Polished internals
Rampage Board
Rampage Pro-E Trigger
TechT A-5Mod
QEV mod
Lapco autococker Adapter
STIFFI Kit
JCS Power Tube
PALMER Stabilizer
LPK
PsychoZ-DF
Ricochet R5

Definitely get the palmers stabilizer for it.

I wouldn't buy the LPK. It seems it is too expensive for all that it does. It is your decision though. I would definitely get the palmer's.

KALIS-PIMENTA wrote:

DanSD wrote:

Get a regulator. It will help with consistency.

I thought you were getting an APE board...

How do u know ?And yes i am but they only shipping out sometime in march,but i did get a e-grip with the Was board ( because now it comes standard on all e-grips),but of course it was broken and i didn't get to try it.Will the palmers help my accuray? if yes why

Yes, the Palmers might help with your accuracy. It might not be the most notable difference in accuracy, but it will be there. See, the Palmers will make your gun a whole lot' more consistent, thus improving your shot to shot accuracy. See, when your velocities aren't consistent, balls will fly at different speeds, affecting their flight paths, making them lees accurate than they would be with consistent velocities.

KALIS-PIMENTA wrote:

I wanted to know if i should get a low pressure system or/and a palmer stabilizer & what would be the improvements ( my complaints r :not accurate,1shoot here,next shoot way out there).My setup is:

A-5,r/t or e-grip w/ WAS board,JCS Red Hot Power Tube,hpa 4500 88ci, apex, j&j & bigshoot.

With an A-5 there seems to be little value in installing the LPK. (I am not sure that the LPK in any of the Tippmanns has much value unless you are using an E-Bolt. Problem is that these markers are designed to work in a wide range of pressures, but they cannot be made to function correctly below about 400 psi. Failure to cycle and cock is the problem with running too low pressure. With the E-Bolt the need for cocking pressure is eliminated and pressures then can be dropped below 200 psi...reducing gas usage and barrel report.) But the value of the Palmer Stabilizer is significant. With the regulator shot to shot pressures stay dead on with little to no spiking even with CO2. Shot-to-shot consistency in pressure gives shot-to-shot consistency in velocity...allowing all shots the hit the same point of aim.