X7 E grip? No contact.

My X7 started acting up on me yesterday on the field. It would not switch into automatic so I used it semi with no problems.
The light was blinking green and after messing around with the selector (switching modes pushing it up and down) it started firing auto again.
Shortly after it started working it stopped firing all together there is no noise when I pull the trigger and the sear doesn't jump but the light in the grip still reacts normally (blinking green pull trigger then yellow release blinking green again) I changed the battery and now it appears to be blinking orange and when I pull the trigger it turns red when the magnet moves through the sensor.

Is my sensor messed up? I don't understand how it recognizes the trigger but does not release the actuator.

sounds like a loose wire or a short. Look carefully at your board for any bare wires. May also be moisture. Expose it to air for a few days, and disconnect the battery.

If none of those work, hope its under warranty.