center fed top-front cocking 98c

been working on this for a while i had to make my own center feed i wanted one that hinged just like stock since no one makes one i had to take matters into my own hands. after that i decided i wanted to cock it in a unique way, top cocking is cool but i wanted something i haven't seen before so after alot of thought i decided to go with a top-front cocking (mabey someone has done this but i haven't seen it). then i wanted to do some custom milling i rounded off the top where the dovetails used to live and filled the bottom where the round part meets the square and created a radius, then i welded shut the original cocking slot, front velocity adjuster hole, warnings and finialy welded shut the rear sight hole. after all the welding and filing was done i finished milling the rear sight and the finger grooves on the foregrip. when the gun was done i turned to the x-chamber i removed almost an inch in length (i removed one of 4 stages to achieve this) to improve the looks. after all that i primed and painted. enjoy

feel free to rate it and leave your comments

if you want to know how i did the centerfeed check it out at the paintapalooza forum here http://paintapalooza.myfreeforum.org/index.php

go to marker gallery and then to FINISHED centerfeed updated 7-7

hope you enjoy looking at it as much as i enjoyed doing it!!!!

Could you post the specs?

Is that a palmer stab?

Snake6 wrote: Could you post the specs? Is that a palmer stab?

m98c
14" j&j ceramic barrel
flatline
R\T
apache hopper
custom RVA
custom drop forward
custom centerfeed
top-front cocking
4 stage x-chamber modded to 3
custom milling

specs are in the sig the hopper is in the mail as we speak, and the x-chamber is a cmi 4 stage cut down to a 3 stage (for looks) other than the R/T, flatline, J&J, hopper, x-chamber everything is homemade.