|
stripped screw on a 98 custom |
Post Reply 
|
| Author | |
warman 
Member 
What the duece happened Joined: 10 June 2002 Location: United States Status: Offline Points: 215 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: stripped screw on a 98 customPosted: 24 March 2005 at 12:31am |
|
two of the bolts on my buddies 98 are stripped. They are both bolts needed to disasseble the gun. and i was wondering what the easiest way to remove them so they can be replaced. before my friend starts hitting his gun with a hammer... oh wait it's too late
|
|
|
N is for nowledge
|
|
 |
|
|
The Guy
Platinum Member 
Soup Can Guy Joined: 18 March 2004 Status: Offline Points: 6666 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 March 2005 at 12:50am |
|
well if its too late then I won't answer.......
Craftsmen Screw-out, or cut a slot in the top with a dremel and use a flathead screwdriver. |
|
|
|
|
triggerhappy1
Platinum Member
Joined: 07 May 2004 Location: United States Status: Offline Points: 3376 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 March 2005 at 9:01am |
|
You can get an extractor bit and take any stripped screw out. Or get JB Weld and a new allen wrench and bond the wrench in the whole and unscrew it when it sets. Or cut a notch in the head with a Dremel and unscrew it with a flat head screwdriver.
|
|
|
|
|
|
|
yankeeboystevel
Member
Joined: 25 March 2005 Status: Offline Points: 2 |
Post Options
Thanks(0)
Quote Reply
Posted: 25 March 2005 at 9:23am |
|
I accidentally stripped the place where the two valve bolts go in. One isn't that bad. The other... whenever you put a screw in, it gets rocketed out. Any suggestions?
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options