Response Trigger on A5 problems

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have 2 A5s with RT triggers that are malfunctioning. Both are on older A5s running off of a new 20oz bottle and a fresh refill and a remote line.  I've searched everywhere for similar problems, read the tippman troubleshooting info, checked all O rings, oiled them, and there is no debis in the line. 

Gun 1: 
I get about 1 ball per second when holding pressure on the trigger. I've tried the tuning steps but when I fully tighten the flow control I never get that "too hard to pull" feel on the trigger. 

Gun 2:
No pressure at all when pulling the trigger. The piston seems to be firing but it only fires semi auto. There is no pressure at all with a fully tightened flow control valve. I've even tried tightening the velocity screw for more back pressure but to no avail. 

What should I check next?

Edited by Ih181 - 20 April 2014 at 1:38am

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Ih181 Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 20 April 2014 Location: NC Status: Offline Points: 1	Post Options Post Reply Quote Ih181 Report Post Thanks(0) Quote Reply Topic: Response Trigger on A5 problems Posted: 20 April 2014 at 1:34am
	I have 2 A5s with RT triggers that are malfunctioning. Both are on older A5s running off of a new 20oz bottle and a fresh refill and a remote line. I've searched everywhere for similar problems, read the tippman troubleshooting info, checked all O rings, oiled them, and there is no debis in the line. Gun 1: I get about 1 ball per second when holding pressure on the trigger. I've tried the tuning steps but when I fully tighten the flow control I never get that "too hard to pull" feel on the trigger. Gun 2: No pressure at all when pulling the trigger. The piston seems to be firing but it only fires semi auto. There is no pressure at all with a fully tightened flow control valve. I've even tried tightening the velocity screw for more back pressure but to no avail. What should I check next? Edited by Ih181 - 20 April 2014 at 1:38am