Response Trigger Trouble

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I installed my response trigger today but i cant seem to get it to perform like its supposed to.  i turned the flow control all the way in, then slowly back out.  while there was some difference in ROF, it was very slight.  i do feel it pushing my finger back but its not fast at all.  to be honest, i could shoot faster manually.   and when i pull the trigger with the same pressure i get varied ROF's.

Can anyone can give me some tips, particularly on "finding the sweet spot.."

also, will upgrading to super R/T help my problem?  

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
$uperm@n_708 Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 12 April 2009 Status: Offline Points: 44	Post Options Post Reply Quote $uperm@n_708 Report Post Thanks(0) Quote Reply Topic: Response Trigger Trouble Posted: 13 August 2009 at 9:25pm
	I installed my response trigger today but i cant seem to get it to perform like its supposed to. i turned the flow control all the way in, then slowly back out. while there was some difference in ROF, it was very slight. i do feel it pushing my finger back but its not fast at all. to be honest, i could shoot faster manually. and when i pull the trigger with the same pressure i get varied ROF's. Can anyone can give me some tips, particularly on "finding the sweet spot.." also, will upgrading to super R/T help my problem?
	98 Custom Pro Platinum Response Trigger DOP Rocket Cock 2 Lapco Bigshot 12" w/Apex Tip Tippmann Triumph Hopper HPA 90/4500 Polished Internals

TinMan Members Profile Send Private Message Find Members Posts Add to Buddy List Gold Member Joined: 10 October 2007 Status: Offline Points: 1003	Post Options Post Reply Quote TinMan Report Post Thanks(0) Quote Reply Posted: 19 August 2009 at 6:52am
	Most RT issues I have seen are from interference in the pass through connector. Remove the RT, use a 1/4 inch drill to clean up the hole in the right shell half. make sure the inside fitting will pass through the hole. reassemble. Good luck with it.

oelfkp Members Profile Send Private Message Find Members Posts Add to Buddy List Member Joined: 22 December 2004 Location: United States Status: Offline Points: 22	Post Options Post Reply Quote oelfkp Report Post Thanks(0) Quote Reply Posted: 19 August 2009 at 9:22pm
	Not to state the obvious but you do have enough air correct? A lot of response trigger issues come from air issues. Low PSI, hose issues, leaks, etc. Also if the response trigger is used, a little oil around the prong and some gentle love on the prong may help.
	1 Timothy 4:12 - "Don't let anyone look down on you because you are young, but set an example for the believers in speech, in life, in love, in faith and in purity."