Stick Feed For The 98 Custom

WHY? im confused, if you have a tubing bender or welder you can. but why?

why is a good question.  The Answer is because i am a sniper.

o no i can hear the flames comeing. o well. do you want it so you want take it off and put a reg hopper on it or not? the easiest way i can think of is just getting a tube and sticking it in the elbow. if you want to get rid of the elbo all together you could drill two holes in the receiver and make them recesed(sp)(on the inside that way you won't run into the problem with them getting in the way of the paintball) then make an adapter that would fit the tubes and have the peice fit on the side of the gun using the two holes. on the end of the adapter you could have an adjustale feed neck type of thing or like a clamping feed neck that way you can just use the tubes that you store them it.



sorry how small it is but go to putfile.com/sockfootball21 and click on it, that way you can see it close up


i hope this is what you were thinkin about

I made these as emergency back up...when all my pods are empty. Joints on the 90 degree elbow are glued. Cap is friction fit.

 

 

Edited by Bruce A. Frank - 17 March 2006 at 8:35pm

why not have a 45 degree angle so it will load that from gravity insteed of aiming ur gun down or shakin it

PaintballPIMPIN wrote: why not have a 45 degree angle so it will load that from gravity insteed of aiming ur gun down or shakin it

If you are buying standard plastic pipe parts then you are limited to specific angles. You may find a 45° fitting.

If you want it to gravity feed, then omit the 90° and stick the tube straight up!